11/22/2023 0 Comments Carbon fiber car wrap![]() At this point, ensure that the entire panel is covered without any edges of the panel exposed. Have that person help you position the vinyl and drape the film over the panel. With someone helping you, carefully remove the backing paper while applying some tension to the film, so that less creases appear. Try not to unroll or place the film on the floor, as this will leave dust and debris on the film, causing scratches when applying with a squeegee. ![]() Unroll the desired amount of film and cut using a utility knife. Using your tape measure, roughly measure the surface of the panel you are applying to, leaving extra material (at least 4-6 inches) on either side. ![]() We recommend researching how these objects stick to the car and the best method of removal. We recommend applying the film to flatter areas first, just because these tend to be simpler and more convenient to get out of the way.Ĭheck to make sure there is nothing hindering your application, such as logos, hood ornaments, and other bulky objects that won’t be wrapped. Proceed to apply the film as soon as possible to reduce the amount of dust and contaminants that may accumulate on the surface over time. If necessary, use a blow dryer or heat gun to speed up the process. Make sure the substrate is completely dry before applying the film. Alcohol is best used for spot cleaning and a quick wipe-down. Alcohol-based cleaners, such as isopropyl alcohol may be used, but is not as effective at removing wax in comparison to solvent-based cleaners. To remove these contaminants, we recommend using a grease and wax cleaner. Surfaces with any grease, oil or wax greatly reduce film adhesion and may form bubbles on neglected areas. This may be time consuming, but often these edges, especially in vehicle wrapping installations, are where the ends of the film are anchored and may peel off if not properly cleaned. Each swipe should be done with a clean portion of the towel until the towel shows no dirt on the swiped edge. To clean hard to reach edges, wrap a lint-free towel over a squeegee and proceed to swipe multiple times. Pay particular attention to ridges, edges and seams as these areas are often neglected and may carry the most dirt and grime. Thoroughly dry the surface with a clean lint-free towel or lint-free paper towel. Then proceed to rinse the surface with water. We recommend to have the car generally cleaned with car wash soap (avoid using cleaners with waxes). The first step is to clean the surface with paint-safe grease and wax remover to remove any dirt or grime on the surface. VViViD® uses a paper liner that is effected by moisture and humidity, it is paramount to keep the vinyl in a dry place. When storing vinyl after using the product, make sure the material is tightly wound around the core. Keep humidity as low as possible and always store the vinyl vertically. When storing vinyl, try not to expose the film to heat sources (radiators, heaters) We strictly recommend applying film indoors, as this will not only help maintain aĬonsistent temperature, it will also reduce the amount of dust and contaminants ![]() If the temperature is too low, there is a higher risk of tearing as the cold makes the film more brittle. If the temperature is too high, the adhesive will activate and bond more aggressively, this will add difficulty when repositioning the vinyl on the target surface. We recommend a working temperature to be in the range of 22 C. Temperature plays a critical role in how well the vinyl adheres to the substrate.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |